Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1]   Go Down

Author Topic: Fault code help need please  (Read 953 times)

0 Members and 1 Guest are viewing this topic.

retro_al

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
Fault code help need please
« on: 06 November 2007, 10:29:37 »

I have done the paper clip test and it flashes 5 times then pause then 9 times,ive try to look it up but cant seem to fiqure which fault it is :'(anybody have a beter idea than me?

thanks for the help  :)
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 33982
  • Git!
    • View Profile
Re: Fault code help need please
« Reply #1 on: 06 November 2007, 10:33:31 »

What engine and year?
Logged

retro_al

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
Re: Fault code help need please
« Reply #2 on: 06 November 2007, 10:34:23 »

Quote
What engine and year?
is a 2.5 v6 on a n reg  :)
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 33982
  • Git!
    • View Profile
Re: Fault code help need please
« Reply #3 on: 06 November 2007, 11:15:23 »

Its related to the rear multiram solenoid which is mounted on the rear of the plenum.....has the plenum been removed recently??
Logged

retro_al

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
Re: Fault code help need please
« Reply #4 on: 06 November 2007, 11:17:35 »

Quote
Its related to the rear multiram solenoid which is mounted on the rear of the plenum.....has the plenum been removed recently??
no only thing ive done is change the plug leads and the crank sensor
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 33982
  • Git!
    • View Profile
Re: Fault code help need please
« Reply #5 on: 06 November 2007, 11:23:07 »

Right

Well check the back right hand corner of teh plenum, you should see a small solenoid with a 2 pn connector and some vac hoses on it.

Make sure its plugged in and there is no damage to it.

If you look at the following picture which is a shot of the rear of the engine, you will see the item bolted to the back of the plenum...



I wonder if it was damaged/disconnected whilst the crank sensor was being changed.
Logged

retro_al

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
Re: Fault code help need please
« Reply #6 on: 06 November 2007, 11:25:48 »

ok thanks for the help.i shall go have a look  :)  :y
Logged
Pages: [1]   Go Up
 

Page created in 0.012 seconds with 17 queries.