Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Engine coolant change/flush.  (Read 631 times)

0 Members and 1 Guest are viewing this topic.

Mikes1670

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 162
    • View Profile
Engine coolant change/flush.
« on: 04 May 2010, 09:27:55 »

Hi all, my mind has gone blank - I'm not a morning person! I am going to change my coolant from blue anti-freeze to Vauxhalls long life red anti-freeze. Can someone please direct me to the procedure on how to flush the coolant system. I understand that the V6 cannot be drained completely.

TIA.
Logged

Jimbob

  • Global Moderator
  • *****
  • Offline Offline
  • Gender: Male
  • Chester / Flintshire
  • Posts: 24523
  • I like traffic lights, but only when they're green
    • E250 Est / Golf GTI
    • View Profile
Re: Engine coolant change/flush.
« Reply #1 on: 04 May 2010, 09:36:04 »

there are guides on this in the maint section, link to the index in my signature  :y

Mikes1670

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 162
    • View Profile
Re: Engine coolant change/flush.
« Reply #2 on: 04 May 2010, 09:42:05 »

Found it, cheers Jimbob - I had been looking in common issuess and FAQ's section!!
 :y :y :y
Logged

Hannah Judes Dad

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Cleethorpes North East Lincs
  • Posts: 1933
    • the misses round the bend
    • View Profile
Re: Engine coolant change/flush.
« Reply #3 on: 04 May 2010, 09:48:33 »

First thing is to remove header tank cap then get under neath the car and open the drain bung at the bottom of the radiator (passenger side) to release the old coolant.Once you have deposited most of thie coolant on to your arm/driveway now is a good time to think about getting a drip tray!! Flush the system through several times with water to make sure as much of your old coolant is removed from the sytem.How many times have you wished for that drip tray? Once you are happy that the old coolant is out refit the drain bung you know the red one that came out in your hand with frustration after being stuck in for ages.Make up your coolant to the dilution that you want then add to the system via the header tank until you reach the required level on your header tank.Close the cap on the header tank,start the engine and put the heater up to hi.allow the engine to run for about five minutes then switch it off.Carefully remove the header tank cap and 'burp' the system for any airlocks then top up as required with coolant trying not to burn yourself in the process.I hope that helps.
Logged
Don't wee on the electric fence

Hannah Judes Dad

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Cleethorpes North East Lincs
  • Posts: 1933
    • the misses round the bend
    • View Profile
Re: Engine coolant change/flush.
« Reply #4 on: 04 May 2010, 09:49:07 »

Must type quicker ! :D
Logged
Don't wee on the electric fence
Pages: [1]   Go Up
 

Page created in 0.012 seconds with 17 queries.