Well then, a much needed update folks.
The trackday at Bedford went really really well, in fact I can't believe how well it went. It got me there with no hassle, did a full track and got me 2 and a half hours home too.
It managed 118mph but we subsequently limited ourselves to 110mph as there was a fair bit of vibration near 120mph.
It burnt its way through £125 of fuel on the track alone
It covered 250 miles on track alone
And I'm confident in saying it was the single most used car of the day.
My two brothers and I drove the car, it came into the pits, was left running while we swapped drivers and went out again, non stop until lunch then again afterwards with a fairly early finish at 4 ish.
The engine behaved perfectly, the cooling system is up to the job, the brakes didn't overheat or fade or boil.
The handling was awesome, this was a worry of mine as I've done all the calculations but never pushed it. It was so predictable, full of feedback, and really well balanced, I'm over the moon with the handling.
And it performed really well, there were some serious cars there and I think the Scim and the three drivers were about a third of the way up the field, with plenty of vx220s, lotus', a GTR lots of BMWs etc being pretty dam fast. The Scim showed up lots of hot hatches, the odd elise, a 944, an E36 M3 (although I'm sure that's more about the driver). Suffice to say I'm really really pleased with how it went.
There were a few points to work on. The rebalanced propshaft has meant that the vibration at 80mph has gone, but there is still a vibration at 120mph (this will be a little harder to sort out on the road).
The front discs have cracked too. I'll go on about this a bit more in another post, but I won't be buying cheap drilled discs again. And that's about it really!


Anyway enough of that. Here are a few snaps of the car on track, firstly my younger brother pushing on just a little too much








Next the car is off the road for a couple of months until funds allow. In the mean time, an inspection of the important bits, new discs all round, road seats back in, and try to locate the vibration problem.
More to come